My inspiration came from the Vintage Industrial Steel Cabinet from Restoration Hardware.
|Vintage Industrial Cabinet from Restoration Hardware Baby and Child|
These are the supplies that you will need to do a faux aged steel paint finish:
**There may seem to be a lot of steps, but this paint treatment is just a matter of sanding, dry brushing the paint on and then wiping it off. **
Sand your piece of furniture with the 220 grit sandpaper till it’s no longer shiny, even when you wipe off the dust.
Wipe it down with vinegar or mineral spirits. These two steps will prep your furniture for the paint and give your paint something to grab onto.
Lightly dip your brush into the chalkboard paint and dab most of it off onto a paper plate.
“Dry brush” the paint lightly on your surface.
As soon as you finish your first section, wipe off the paint with a dry rag.
The sanded surface will catch most of the chalkboard paint.
(Ignore the faux rivets in this picture. I was trying to decide if I liked them.)
It looks messy, but it gets better. The good thing about this paint project is that it doesn’t have to look perfect.
After you have done this with the entire cabinet, you want to apply the silver craft paint.
Put a couple of tablespoons of the Gunmetal silver craft paint onto a paper plate and add about a half teaspoon of water to thin it out.
Take your paint sponge and dip it into the silver paint and dab most of it off onto your paper plate. This is also a “dry brushing” technique.
Lightly streak this paint onto the surface in one direction. If you get too much on, just wipe it off in one direction.
I let this dry for about 2 hours.
Now it’s time for the magic to begin!
Take a scoop of the dark wax and put it on a paper plate. Blend in a small amount of mineral spirits, just enough to thin it out.
Take one of your paint brushes and dip just the tip of the bristles into the wax and dab most of it off onto the paper plate.
Lightly drag the brush in one direction over your surface. This will prevent you from getting too much wax on at one time.
Now, take your clean paint brush and buff in the wax in a circular motion. Don’t let your wax dry too long before you get to the buffing step.
Let this dry for 5 minutes.
Take your “Better Than Cheesecloth” Buffing towel (I bought mine at the same store that I bought my Annie Sloan Dark Soft Wax) and start buffing out the wax so the surface has a nice, thin layer.
The dark wax is what really gives the piece a nice patina. It also protects all of your hard work.
*If you don’t want to invest the money in the Annie Sloan Dark Wax, you can try using a diluted dark umber craft paint. You will have to still have to protect your finish with 2 coats of polyurethane.**
I let the first coat of wax dry about 30 minutes before applying the second coat.
Check out these other Restoration Hardware knockoffs that’ll knock your socks off:
- Easy and Cheap DIY Wooden Poster Hanger & Knockoff RH Vintage Lithograph Maps
- DIY Balustrade Coffee Table Inspired by Restoration Hardware
- Knockoff Restoration Hardware Bristol Flat Mirror
- Restoration Hardware Inspired Cage Pendant Light